Progress

This post is just to show the progress I have made since my Presentation until now. As I mentioned earlier I have been focusing the majority of my time on my other modules as the submission where before this submission.

I have focused mainly on improving from where I left off and neatened and tidied the geometry and shape of the chest.





I Know it doesn't look like I have done that much to it but it is a lot trickier than it looks. I want to make sure that the shape I make is correct as I go along so I don't have to go back and make corrections. This is why I have been using turbosmooth throughout to check how the geometry looks and flows.

I am now at a difficult pat of the suit where the schematic I'm following doesn't cover the part I'm modelling (Under the arm pit). As well as this I am also at the point where I am moving from the front of the model to the back and I need to ensure that I match the front and back perfectly, as well as not editing both sides at the same time. That is another reason why it looks like less work has been done as I was accidentally moving the front of the model out of place when I was modelling the back and had to delete it and start from the beginning again.


This is just a small update, hope you like it